![]() Open the EFI partition of your USB Drive and go to: Now click Install, it will open a prompt for your Username Password, write it and press Enter, the installation will start.Īfter bootloader installation ends, your EFI partition of the USB Drive will be mounted. You can change it later to whatever theme that you want, steps will be explained in the customization section of the guide. Select BGM (Black Green Moody) as it's the one that i already set on the ist for installation and usage. If you need FileVault 2, checkmark the FileVault drivers by selecting / check marking the ones listed below on the screenshot: Make sure you don't touch the UEFI Drivers as they are already pre-configured but just in case to make sure everything is correct, make sure to check the picture down below to see if all needed drivers are selected accordingly: Select / Checkmark the settings as listed on the picture above or listed down below: That brings us into the customization section of Clover Bootloader where we select the appropriate configuration for our hardware like seen in the screenshot down below: Make sure to click on "Change Install Location." like in the screenshot above and then select the USB Drive as shown in the screenshot down below:Īfter you selected your USB Drive, click "Continue", now after this step, click on "Customize" as seen in the screenshot down below: ![]() ![]() Open Clover bootloader installer, click on continue, agree, continue and when you reach this screen: If you are using a real MacBook or iMac, if you accidentally install Clover Bootloader into the real iMac / MacBook that you are using, you might brick it, so be careful and choose the USB drive for installation! ![]() Install Clover Bootloader by carefully following the steps explained down below: Prepare USB Drive with the correct configuration, kexts, Bootloader, ist and ACPI VoodooI2CELAN.kext - attached at the end of the guideĮFICheckDisabler.kext - attached at the end of the guide VoodooI2C.kext - attached at the end of the guide I listed all the needed kexts down below which are in form of hyperlinks and should direct you straight to the download page: Press F2 repeatedly after powering on the laptop to enter BIOS (more informations will be added soon, work in progress)īefore proceeding with this guide i would highly suggest that you begin with a clean install rather than upgrading as the method and kexts are different than what you might be currently using on your laptop.ĭownload Clover Bootloader version of 2:įormat USB Drive as HFS+J with GPT partition table and make sure to name it: install_osxĭownload macOS Mojave from the Mac App Store, after the download process has finished, now create the USB Installer by opening terminal and writing the following command:Ĭode: sudo "/Applications/Install macOS Mojave.app/Contents/Resources/createinstallmedia" -volume /Volumes/install_osx -nointeractionPress "Enter" and it will ask for your User password, after you entered password, wait for the process to end, it should take around 10-30 minutes.ĭownload all the needed kexts for "Pre" and "Post" installation. ![]()
0 Comments
Leave a Reply. |